Portable power · Guide

Watts vs watt-hours: don't buy the wrong power station

Every portable power station lists two headline numbers. One tells you what it can run. The other tells you for how long. Mixing them up is the most common sizing mistake.

Research-based guide · No products tested for this article · Last reviewed September 30, 2026

The short version

SpecWhat it measuresQuestion it answers
Watts (W)Power: the rate energy is delivered at a given momentCan it run this device (or these devices) at the same time?
Watt-hours (Wh)Energy: how much the battery storesHow long can it keep running them?

A useful picture: watts are how wide the tap opens, watt-hours are how much water is in the tank. A big tank with a narrow tap cannot run a hungry appliance. A wide tap on a small tank runs it — but not for long.

Watts: can it run your device?

A power station's output is usually listed as a continuous (rated) output in watts, and often a higher surge or peak figure. The continuous rating must be higher than the total running power of everything you plan to plug in at the same time.

Finding your device's watts

Don't forget startup surge

Devices with motors or compressors — refrigerators, pumps, some power tools — can briefly draw much more than their running power when they start. If that startup demand exceeds what the station can supply, the station may shut off its output to protect itself. Compare the device maker's startup requirement, when available, with the station's surge rating.

Watt-hours: how long will it last?

Capacity in watt-hours tells you how much energy is stored. Dividing it by your device's power gives a theoretical runtime:

Theoretical runtime (hours) = capacity (Wh) ÷ device power (W)

Real runtime is shorter. Converting battery power to AC outlet power loses some energy as heat, the station itself uses power to run its electronics, and many devices change how much they draw over time. The loss varies by model and load, so we apply an assumed efficiency factor for planning:

Estimated runtime ≈ capacity (Wh) × efficiency ÷ device power (W)

Illustrative example (not a specific product). A station rated at 1,000 Wh runs a device that draws 60 W. Theoretical runtime: 1,000 ÷ 60 ≈ 16.7 hours. If we assume 85% efficiency for planning, the estimate drops to about 1,000 × 0.85 ÷ 60 ≈ 14 hours. The 85% figure is an assumption for illustration; check the manufacturer's documentation and allow a margin.

Running several devices? Add their watts together and use the total in the formula. Devices that cycle on and off, like refrigerators, use less energy than their running watts suggest over a full day, which is why an energy figure (Wh per day) from the device maker is more useful when available.

Three questions before you buy

  1. What is the most power I need at one time? Add the running watts of everything used together. The station's continuous output should exceed it.
  2. Does anything have a startup surge? Compare it with the station's surge rating.
  3. How long do I need it to run? Multiply the power by the hours to get the watt-hours you need, then add a margin for losses.

A bigger number on the box does not answer all three. A high-capacity station with modest output may not start your appliance, and a high-output station with small capacity may run it only briefly.

Safety note. A portable power station is not a substitute for a whole-home backup system. If you depend on powered medical equipment, such as a CPAP machine or oxygen concentrator, ask the equipment manufacturer and your healthcare provider about suitable backup power before relying on any battery product.

Next: use the portable power buying checklist to confirm the rest of the specs.

Sources